A repair shop earns trust one job at a time. Every entry below is a real job that came through the bench: the device, the symptom, and what we actually did. No customer names, ever — the gear is the story.
Symptom: intermittent distortion and a right channel that would fade to almost nothing
What we did: traced to a dirty volume control with a knob working loose on its shaft — cleaned with proper contact treatment, reflowed the control’s pins, tightened the knob, and verified DC offset at the speaker terminals on both channels. It left measuring even from FM to tape to aux.
Symptom: skipping on every disc — but only after it had been playing a while
What we did: a transport drying out with age: full disc-tray teardown, deep internal clean, careful laser cleaning, every factory grease point re-lubricated, then hours of burn-in instead of minutes. the full story →
Symptom: faceplate buttons jammed and unusable
What we did: a seized screw trapped behind the faceplate — extracted it, realigned the panel and confirmed every button working again, then cleaned the unit and tested it through its full range.
Symptom: blowing its fuses the instant it powered up
What we did: a blown B+ trace and a protection diode shorted dead — quoted with photos and repaired only after written approval, with under $5 in parts. The fuse-killer stopped killing fuses. the full story →
Symptom: slow at everything — boot, browsing, all of it
What we did: dried-out thermal paste and the original spinning hard drive: fresh paste, a 512 GB SSD upgrade, and a clean factory Windows install. A barely-used machine underneath the age.
Symptom: running hotter than ever after a warranty motherboard replacement
What we did: load testing proved the hardware was right all along — the heat was startup software dragging the machine down. An honest diagnosis with no unnecessary work sold. the full story →
Symptom: running hot under daily use
What we did: thermal service and a stubborn background process — temperatures verified at idle afterward, with fan and paste both exonerated by the numbers.
Symptom: loud rattle at boot and under load
What we did: a CPU fan connector that was never fully seated, dried paste, and a dust load — reconnected, repasted, cleaned out. Quiet again, with a cooler upgrade noted for the future.
This page grows with every job — check back.
Want the deeper stories? The Odd Bench carries the long-form versions, and the bench page shows what’s in the shop right now. The straight ledger includes the jobs that didn’t go to plan.
Bring it in or ship it. I diagnose it, you approve the quote, I fix it.